Retaining Wall #1

Clean up my existing design, COGO Point Bearing distance to create garage points, 3d view to see measured surface. Create breakline for slab and offset line.

Retaining Wall #2

COGO point bearing distance to create bottom of wall corners.

Retaining Wall #3

Create break line along slab for better triangulation, COGO free pick point for wall tie in. Create line and connect bottom of wall points. Create offset line for top of wall and back of wall, view in 3d surface.

Retaining Wall #4

COGO create lines and enter elevation, to create contours. Add additional lines for driveway.

Retaining Wall #5

COGO free pick points on spot grades,    Create break line for the driveway. Save surface as design. Change project design to wall V1.