Box Culvert #1
Create project, set up Base and connect Rover. Perform 1 point no Control Point Calibration.
Box Culvert #2
Measure existing control points, Import PDF background image, Check additional control on plans.
Box Culvert #3
Topo existing road using break lines. Edge of Pavement west, centerline and edge of pavement east.
Box Culvert #4
Measure inverts of existing culvert as feature points. Use offset measurement to get invert from top of culvert. Measure Sewer Manhole of existing as well. Create feature line for existing sewer.
Box Culvert #5
Create box build work order, import detail sheet of culvert, measure alignment of culvert, COGO to get exact distance and bearing. Edit point elevations to match invert in and out.
Box Culvert #6
COGO create offset lines for bottom of Box and stone over dig. Create offset lines to create 2 on 1 tie slope. Save surface as design. Change project to load new design.
Box Culvert #7
COGO create offset line for box edge, Create points for wingwall using point bearing distance. Offset line for stone over dig and create wing wall and offset slope for dig out
Box Culvert #8
Change project to road topo design, save surface as design and merge surface with measured surface, load new merged surface in the project for saw cut layout etc.
Box Culvert #9
Create offset line for edge of box, create points for wingwalls, offset line including wing wall, save surface as design.
